Cutting Floor Out Of A Boat

Posted by pina on June 18, 2019 with No comments





The plywood floor cut out for 1987 sunray omc. i pulled the carpet out nd saved it so i can use the outline to cut out the new one i did the same with the original rotted plywood . i pulled it out. Step 1 - remove the damaged flooring. the most common material used for boat flooring is bc plywood, and it is also used for fiberglass boats in particular. start removing the old damaged material using an electric saw to cut it; if the stringers and bulkheads are rotten, get them replaced with fiberglass ones.. A boat floor is not meant to have nails in it and doing so weakens the structure. it also creates spaces where water can get deeper into the boat, the floor, and other areas. even a gap as small as a nail head can wreak havoc on an otherwise healthy boat so when replacing flooring, avoid nailing altogether..





H6K5 Mavis by Steve Hustad


H6k5 mavis by steve hustad




301 Moved Permanently


301 moved permanently






Drywall and Mud and Electric, Oh My


Drywall and mud and electric, oh my


I plan on buying a new sheet of 4 by 8 plywood , cutting out the old wood exactly so i can fit a new sheet right in, the cut the livewell hole out of it. my question is, i have never seen below the floor of a fibreglass boat, and am unaware of any hazards i may encounter with the sawzall, lol.. Image result for jon boat deck ideas boats pinterest from boat flooring material. boat flooring material what you should remember when buying floor plans online, many people have a normal gray concrete floor within their garage.. There are only 2 ways to find the leak and thats going to be to pull the floor out, pull the foam out, and float the boat. or, set it up on blocks, and flood it. in the end you will most likely end up tearing the foor out..


cutting floor out of a boat